 Choose a door groove suitable for the case of the lock on the picture.
Make a reach-through hole for the installation of the lock eurocylinder according to the picture .
The aperture for the output of a cable should be made according to the local conditions and requirements on installation.
The required output of the spring-bias roller should be installed on the basis of the size of the gap between the door-frame and the door edge +3mm. For instance if the distance between the door-frame and the door edge is 4mm, the output of the roller should be 7 mm from the surface of an lanch lock plate.
Connect the wires of external connection according to the picture.
ATTENTION!
Red wire – «+10, 8…16V DC»;
White wire – «common»;
Green wire – «opening control - OPEN»;
Yellow wire – «signal – DOOR».
(the «DOOR» signal is provided by the «ground» signal in cases of the lock opening by means of the motor, by means of a key, at an incomplete crossbar exit or at the breaking of the door).
Install the lock into a door groove so that not to break the cable.
Fix the lock by means of two screws (see parts checklist).
Install a lock eurocylinder into the lock and fix it by means of the screw M5x55 (see parts checklist).
Check the lock operation by means of a key and make sure that the crossbar runs without jamming.
Make a marking for the fixing of gripping plate on the door-frame; the crossbar should be in the put forward position.
Choose a groove (the depth of it should be 3mm) for fixing of gripping plate according to the above-mentioned marking.
Make an aperture 12mm in diameter for the magnet and a groove for the crossbar (the depth of the groove should be 20mm).
Fix the gripping plate by means of three screws having drilled beforehand an aperture for the screw, 3, 5mm in diameter and 25mm in depth.
Shut the door and make sure that the crossbar runs properly.
|
;){kind=link}
